D-Link DGS-1210-28XS/ME [71/519] Command parameter

DGS-1210/ME Metro Ethernet Switch CLI Reference Guide

LOOPBACK DETECTION COMMANDS

The Loopback Detection commands in the Command Line Interface (CLI) are listed (along with the appropriate

parameters) in the following table.

Command

Parameter

enable loopdetect

disable loopdetect

config loopdetect mode [portbase | vlanbase]

config loopdetect ports [<portlist> | all] state [enable | disable]

config loopdetect interval_time <value 1-32767> lbd_recover_time [0 | <value 60-1000000>]

show loopdetect {ports [<portlist> | all]}

Each command is listed in detail, as follows:

enable loopdetect

Purpose To enable the loop back detection on the Switch.

Syntax

enable loopdetect

Description

The enable loopdetect command enables the loop back detection

on the Switch.

Parameters None.

Restrictions Only administrator -level users can issue this command.

Example usage:

To enable the loopback detection feature on the Switch:

DGS-1210-28MP/ME:5# enable loopdetect

Command: enable loopdetect

Success.

DGS-1210-28MP/ME:5#

disable loopdetect

Purpose To disable the loop back detection on the Switch.

Syntax

disable loopdetect

Description

The disable loopdetect command disables the loop back detection

on the Switch.

Parameters None.

Restrictions Only administrator-level users can issue this command.