D-Link DGS-1210-28XS/ME [484/519] Config lldp notification_interval

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide

466

DGS-1210-28MP/ME:5# config lldp reinit_delay 1

Command: config lldp reinit_delay 1

Success.

DGS-1210-28MP/ME:5#

config lldp tx_delay

Purpose To configure the lldp tx_delay on the switch.

Syntax

config lldp tx_delay <sec 1-8192>

Description

The config lldp tx_delay command specifies the delay between

successive LLDP frame transmissions initiated by value/status

changes in the LLDP local systems MIB, use the lldp tx_delay

command in global configuration mode.

Parameters

<sec 1-8192> – Specifies the minimum time in seconds an LLDP

port will wait before reinitializing LLDP transmission. The range is

1 – 8192 seconds. The default configuration is 2 seconds.

Restrictions Only Administrator or operator-level users can issue this command.

Example usage:

To configure LLDP tx delay:

DGS-1210-28MP/ME:5# config lldp tx_delay 1

Command: config lldp tx_delay 1

Success.

DGS-1210-28MP/ME:5#

config lldp notification_interval

Purpose To configure the timer of the notification interval used to send

notifications to configured SNMP trap receiver(s).

Syntax

config lldp notification_interval <sec 5-3600>

Description

The config lldp notification_interval command globally changes

the interval between successive LLDP change notifications

generated by the switch.

Parameters

<sec 5-3600> – The range is from 5 second to 3600 seconds. The

default setting is 5 seconds.

Restrictions Only Administrator or operator-level users can issue this command.

Example usage:

To change the notification interval: