D-Link DGS-1210-28XS/ME [478/519] Lacp commands

DGS-1210 Metro Ethernet Managed Switch CLI Reference Guide

460

LACP COMMANDS

The LACP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in

the following table.

Command

Parameter

config lacp port_priority

<portlist> <value 0-65535> [timeout <long | short>]

show lacp

{<portlist>}

config lacp_ports <portlist> mode [active | passive]

Each command is listed in detail, as follows:

config lacp port_priority

Purpose To set the priority value of a physical port in an LACP group.

Syntax

config lacp port_priority <portlist> <value 0-65535> [timeout

<long | short>]

Description

The config lacp port_priority command sets the LACP priority

value and administrative timeout of a physical port or range of ports

in an LACP group.

Parameters

<portlist> - A port or range of ports to be configured.

<value 0-65535> - Specifies the LACP priority value for a port or

range of ports to be configured. The default is 1.

<timeout> - Specifies the administrative LACP timeout.

• long – Specifies the LACP timeout to be 90 seconds. This is

the default.

• short – Specifies the LACP timeout to be 3 seconds.

Restrictions Only Administrator or operator-level users can issue this command.

Example usage:

To configure the LACP priority of ports 1-3:

DGS-1210-28MP/ME:5# config lacp port_priority 1-3 100 timeout long

Command: config lacp port_priority 1-3 100 timeout long

Success.

DGS-1210-28MP/ME:5#

show lacp

Purpose To display current LACP port mode settings.

Syntax

show lacp {<portlist>}

Description

The show lacp command displays the current LACP mode settings.