Главная
Skipped breadcrumb items
59G824
Инструкция по эксплуатации Страница: 23

Главная
GRAPHITE
59G824
Инструкция по эксплуатации Страница: 23

GRAPHITE 59G824 — инструкции по безопасному использованию дисковой пилы [23/232]

Превью страниц Страница 23 / 232

TRANSLATION OF THE ORIGINAL INSTRUCTIONS

FLIP OVER SAW

59G824

CAUTION: BEFORE USING THE POWER TOOL READ THIS MANUAL CAREFULLY AND KEEP IT FOR FUTURE

REFERENCE.

DETAILED SAFETY REGULATIONS

Safety conditions for ip over saw

When operating the saw strictly follow applicable regulations regarding occupational health and safety. ●

Use only cutting blades recommended by the manufacturer, conforming with the standard PN-EN ●

847-1.

When replacing cutting blade make sure its width does not exceed width of the riving knife. ●

Make sure the cutting blade is suitable for material that you plan to cut. ●

Use only cutting blades with allowable maximum speed greater than maximum speed of the saw ●

spindle.

Do not use cutting blades made of high speed steel (HSS) or with parameters dierent from specied in ●

this manual.

Use only sharp cutting blades, free from cracks and deformations. ●

Immediately replace damaged cutting blade. ●

Make sure direction of cutting blade rotation matches indicated direction of the saw motor. ●

Cutting blade of the saw should be free to rotate. ●

Always use well positioned riving knife and properly adjusted upper shield of the cutting blade. ●

Use a push stick to feed material towards the cutting blade. ●

When cutting wood that has already been used, ensure it is free from unwanted objects, such as nails, ●

screws etc.

Always use anti-splinter goggles, hearing protection and anti-dust mask. ●

Use gloves when handling cutting blades and to protect against other rough and sharp materials. (When ●

replacing a cutting blade hold it by its hole whenever possible.)

Always wear proper clothing for your work! Loose items of clothing or jewellery might get caught by ●

rotating cutting blade.

Before any adjustment, measurement, cleaning or removing jammed pieces of wood always disconnect ●

the tool from power supply with the switch and remove the plug from mains socket!

After repair or maintenance is carried out, install all shields and protective parts before switching on the ●

saw.

Power supply voltage must match value marked on the rating plate of the saw. ●

Connect the saw only to electrical system equipped with residual current circuit breaker that will cut the ●

power o when earth leakage current exceeds 30 mA in less than 30 ms.

When working outdoors use only extension cords designed for outdoor use. ●

Do not use the saw for cutting rewood. ●

Do not keep your hands in position, where there is a risk of unexpected sliding and contact with the ●

cutting blade.

Do not start working with the saw when tired or under inuence of medicines. ●

It is vital that all persons who operate the saw are properly trained for operation, using and adjustments ●

of the saw.

Do not operate, store or leave the saw in places exposed to rain or humidity. ●

Never use the saw close to explosion hazardous liquids or gases. ●

Saw operator should be an adult person. ●

Bystanders should not stay close to connected or operating saw. ●

Check technical condition of the power cord. ●

Do not use the saw if the power cord is damaged. ●

Replace damaged protection parts immediately. ●

Do not overload the saw, causing rotational speed to drop down considerably.

●

Keep the workplace clean. ●

GRAPHITE 59G824 — инструкции по безопасному использованию дисковой пилы [23/232]

Содержание

Похожие устройства