LINE 6 POD HD Pro Руководство по эксплуатации онлайн [123/135] 777362

Appendix B: FBV Foot Controllers

B•21

Assigning an FX Block to the on-board pedal’s “Toe Switch”

Further, if you have a different FX parameter (such as the Volume - Position) being

controlled by the opposite EXP Pedal Mode, you’ll likely ﬁnd it useful to have the Toe

Switch toggle both these FX Blocks On/Off alternately, so that only the desired Model

is active while being controlled. For example, say you have a Preset where the Wah is

controlled by EXP 1, and the Volume by EXP 2:

Note: If you have a “Pedal 2” connected to your FBV (or if using an FBV Longboard) you

may not want to use the following conﬁguration, since the Wah and Volume are already

controlled by your two Pedals individually.

• Click the EXP TOE SWITCH switch so that the red EXP 1 LED is lit.

• In the Signal Flow View, select the Volume FX block and toggle it “Off” using the

ENTER button. You should now see the Wah “On” and the Volume “Off.”

Wah in “On”

Volume is “Off”

• Repeat the previous Footswitch Assign steps for both the Wah and the Volume,

assigning each to the EXP TOE SWITCH.

• Now whenever you click the EXP TOE SWITCH to EXP 1 for this Preset, the

Volume is switched “Off” and the Wah is switch “On” and is controlled by the Pedal

- and vice versa when switching to EXP 2.

• Be sure to save to retain these settings with your Preset!