LINE 6 POD HD Pro Руководство по эксплуатации онлайн [82/135] 777362

Using the Looper

8•2

To follow are descriptions of the functions shown in the Looper screen.

UNDO - Use the Bank Up FBV footswitch to “undo” the last recorded overdub.

You can press this footswitch while actively in Overdub-Record mode, Loop

Playback mode, or while stopped and only the last recorded overdub is erased.

This function will not erase the originally recorded Loop.

PLAY ONCE - Pressing the FBV footswitch plays your recorded Loop (including overdubs,

if you’ve recorded any) for one cycle. Cool for triggering a pre-recorded phrase on demand!

• While playback is active, the Play/Stop icon appears as “STOP,” to indicate

that it can be pressed to stop playback immediately.

PRE/POST - The Looper Block can be moved to either a “Pre” or “Post” position within

the Signal Flow View, which dictates whether Amp & FX processing is added to your

guitar signal during the recording of your Loop, or only for the Loop’s playback.

• PRE: Your guitar signal is recorded unprocessed (i.e. - the Loop is recorded “pre”

Amp & FX processing). When played back, the Loop audio is mixed with incoming

guitar to feed the current Preset’s Amp & FX processing. If you change Presets or

tone settings while set to PRE, you’ll hear them applied to your Loop playback.

• When the Looper is set to PRE, the Pre/Post icon appears as “POST,”

to indicate that the Looper Block can be moved to the “POST”

position.

• POST: Your guitar signal is recorded processed (i.e. - the Loop is recorded “post”

Amp & FX processing). When played back, the Loop audio is mixed with incoming

guitar AFTER the guitar signal has been processed through the Amp and FX. This

provides the ability select a new Preset which is applied only on your guitar input,

while the Loop plays back with the original recorded Preset tone!

• When the Looper is set to POST, the Pre/Post icon appears as “PRE,”

to indicate that the Looper Block can be moved to the “PRE” position.

Note: If you record your Loop in POST mode and then switch to PRE for Loop playback,

this results in the current Amp+FX to be applied to the Loop playback (where the Loop was

already recorded with Amp+FX applied). Be aware that this can cause the Loop playback

to be signiﬁcantly louder!