Qtech QSW-8200-28T-POEAC- DC Команды для настройки портов онлайн [17/85] 481628

User Manual

Chapter 1. Commands for Network Port Configuration 17

www.qtech.ru

module; auto-detected: automatic detection; no-phy-integrated: there is no phy-

integratd 100Base-FX module; phy-integrated: phy-integratd 100Base-FX module;

force1g-half is the forced 1000Mbps speed at half-duplex mode; force1g-full is the

forced 1000Mbps speed at full-duplex mode; nonegotiate disables auto-negotiation

forcibly for 1000Mb port; master forces the 1000Mb port to be master mode; slave

forces the 1000Mb port to be slave mode. force10g-full is the forced 10000Mbps speed

at full-duplex mode.

 Command mode: Port Mode.

 Default: Auto-negotiation for speed and duplex mode is set by default.

 Usage Guide: This command is configures the port speed and duplex mode. When

configuring port speed and duplex mode, the speed and duplex mode must be the

same as the setting of the remote end, i.e., if the remote device is set to auto-

negotiation, then auto-negotiation should be set at the local port. If the remote end is

in forced mode, the same should be set in the local end.

 1000Gb ports are by default master when configuring nonegotiate mode. If one end is

set to master mode, the other end must be set to slave mode.

 force1g-half is not supported yet.

 Example: Port 1 of Switch1 is connected to port 1 of Switch2, the following will set both

ports in forced 100Mbps at half-duplex mode.

 Switch1(config)#interface ethernet1/0/1

 Switch1(Config-If-Ethernet1/0/1)#speed-duplex force100-half

 Switch2(config)#interface ethernet1/0/1

 Switch2(Config-If-Ethernet1/0/1)#speed-duplex force100-half

1.1.18 storm-control

 Command: storm-control {unicast | broadcast | multicast} <packets>

 no storm-control {unicast | broadcast | multicast}

 Function: Sets the traffic limit for broadcasts, multicasts and unknown destination

unicasts on all ports in the switch; the no command disables this traffic throttle

function on all ports in the switch, i.e., enables broadcasts, multicasts and unknown

destination unicasts to pass through the switch at line speed.

 Parameters: use unicast to limit unicast traffic for unknown destination; multicast to

limit multicast traffic; broadcast to limit broadcast traffic. <packets> is the limit of

packet number, ranging from 1 to 1488905. For non-10GB ports, the unit of <packets>

is PPS, that is, the value of <packets> is the number of packets allowed to pass per

second; for 10GB ports, the unit is KPPS, that is, the value of <packets> multiplies 1000

makes the number of packets allowed, so the value should be less than 14880.

 Command mode: Port Mode.

 Default: No limit is set by default. So, broadcasts, multicasts and unknown destination

unicasts are allowed to pass at line speed.

 Usage Guide: All ports in the switch belong to a same broadcast domain if no VLAN has

been set. The switch will send the above mentioned three traffics to all ports in the