Qtech QSW-8200-28T-POEAC- DC [54/85] Ethernet oam mode

User Manual

Chapter 8. Commands for EFM OAM 54

www.qtech.ru

8.20 ethernet-oam mode

 Command: ethernet-oam mode {active | passive}

 no ethernet-oam mode

 Function: Configure the mode of OAM function, no command restores the default

value.

 Parameters: active, active mode

 passive, passive mode

 Command Mode: Port mode

 Default: active mode.

 Usage Guide: At least one of the two connected OAM entities should be configured to

active mode. Once OAM is enabled, the working mode of OAM cannot be changed and

you need to disable OAM function if you have to change the working mode.

 Example: Set the mode of OAM function on ethernet 1/0/4 to passive mode.

 Switch(Config-If-Ethernet1/0/4)#ethernet-oam mode passive

8.21 ethernet-oam period

 Command: ethernet-oam period <seconds>

 no ethernet-oam mode

 Function: Configure the transmission period of Information OAMPDU, no command

restores the default value.

 Parameters: <seconds>, sending period, ranging from 1 to 2 seconds.

 Command Mode: Port mode

 Default: 1s.

 Usage Guide: Use this command to configure the transmission interval of Information

OAMPDU which keep OAM connection normally.

 Example: Set the transmission interval of Information OAMPDU for ethernet 1/0/4 to

be 2s.

 Switch(Config-If-Ethernet1/0/4)# ethernet-oam period 2

8.22 ethernet-oam remote-failure

 Command: ethernet-oam remote-failure

 no ethernet-oam remote-failure

 Function: Enable remote failure indication of OAM, no command disables the function.

 Parameters: None.

 Command Mode: Port mode

 Default: Enable.

 Usage Guide: With remote failure indication is enabled, if critical-event or link fault

event is occurred locally, it will notify the peer by sending Information OAMPDU, log

the fault information and send SNMP trap warning. When the remote failure indication