Qtech QSW-8200-28T-POEAC- DC [52/85] Ethernet oam errored symbol period threshold high

User Manual

Chapter 8. Commands for EFM OAM 52

www.qtech.ru

 Function: Configure the detection period of errored frame seconds event, no command

restores the default value.

 Parameters: <seconds> is the time for counting the specified frame number, its range

from 50 to 450, unit is 200ms.

 Command Mode: Port mode

 Default: 300.

 Usage Guide: Detect errored frame seconds of the port after the time of specific

detection period. If the number of errored frame seconds is larger than or equal to the

threshold, corresponding event is induced and the device notified the peer through

OAMPDU.

 Example: Configure the detection period of errored frame seconds event on port 1/0/4

to be 120s.

 Switch(Config-If-Ethernet1/0/4)#ethernet-oam errored-frame-seconds window 600

8.16 ethernet-oam errored-symbol-period threshold high

 Command: ethernet-oam errored-symbol-period threshold high {<high-symbols> |

none}

 no ethernet-oam errored-symbol-period threshold high

 Function: Configure the high threshold of errored symbol event, no command restores

the default value.

 Parameters: <high-symbols>, the high detection threshold of errored symbol event,

ranging from 2 to 18446744073709551615 symbols.

 none, cancel the high threshold configuration.

 Command Mode: Port mode

 Default: none.

 Usage Guide: During the specific detection period, serious link event is induced if the

number of errored symbols is larger than or equal to the high threshold and the device

notifies the peer by sending Information OAMPDU of which the value of Link Fault flag

in Flags field is 1. Note that the high threshold should not be less than the low

threshold.

 Example: Set the high threshold of errored symbol event on port 1/0/4 to none.

 Switch(Config-If-Ethernet1/0/4)#ethernet-oam errored-symbol-period threshold high

none

8.17 ethernet-oam errored-symbol-period threshold low

 Command: ethernet-oam errored-symbol-period threshold low <low-symbols>

 no ethernet-oam errored-symbol-period threshold low

 Function: Configure the low threshold of errored symbol event, no command restores

the default value.