Qtech QSW-8200-28T-POEAC- DC [29/85] Uldp hello interval

User Manual

Chapter 4. Commands for ULDP 29

www.qtech.ru

4.9 uldp disable

 Command: uldp disable

 Function: To disable ULDP configuration through this command.

 Parameters: None.

 Command Mode: Global Configuration Mode and Port Configuration Mode.

 Default: By default ULDP is not configured.

 Usage Guide: When ULDP is disabled globally, then ULDP in all the ports will be

disabled.

 Example: To disable the ULDP configuration in global configuration mode.

 Switch(config)#uldp disable

4.10 uldp hello-interval

 Command: uldp hello-interval <integer>

 no uldp hello-interval

 Function: To configure the interval for ULDP to send hello messages. The no form of

this command will restore the default interval for the hello messages.

 Parameters: <integer>: The interval for the Hello messages, with its value limited

between 5 and 100 seconds, 10 seconds by default.

 Command Mode: Global Configuration Mode.

 Default: 10 seconds by default.

 Usage Guide: Interval for hello messages can be configured only if ULDP is enabled

globally, its value limited between 5 and 100 seconds.

 Example: To configure the interval of Hello messages to be 12 seconds.

 Switch(config)#uldp hello-interval 12

4.11 uldp manual-shutdown

 Command: uldp manual-shutdown

 no uldp manual-shutdown

 Function: To configure ULDP to work in manual shutdown mode. The no command will

restore the automatic mode.

 Parameters: None.

 Command Mode: Global Configuration Mode.

 Default: Auto mode.

 Usage Guide: This command can be issued only if ULDP has been enabled globally.

 Example: To enable manual shutdown globally.

 Switch(config)#uldp manual-shutdown