Qtech QSW-8200-28T-POEAC- DC [75/85] Show lldp

User Manual

Chapter 10. Commands for LLDP-MED 75

www.qtech.ru

 Parameters: voice, voice-signaling, guest-voice, guest-voice-signaling, softphone-voice,

video-conferencing, streaming-video and video-signaling: the application types are

supported by the port.

 status: Whether the network policy is usable.

 enable: Network Policy of the specified application type has been

defined, enable is the default value of the network policy.

 disable: Network Policy of the specified application type is unknown, the

fields (such as VLAN ID, L2 priority and DSCP) are ignored, network

connection device will not send TLV of the specified application type.

 tag: Configure the specified application to uses tagged or untagged

VLAN method.

 tagged: Configure the flow of the specified application to use the tagged

vlan method, here, the fields (such as VLAN ID, Layer2 priority and DSCP

value) are take effect.

 untagged: Configure the flow without tag for the specified application,

the fields (such as VLAN ID, Layer2 priority) are ignored, only DSCP value

field takes effect. Untagged is the default value of VLAN method.

 vid: Configure VLAN ID that the specified application belongs to. When

the peer sends the flow of the specified application, it will tag the

notified VLAN ID, or else the vlan-id value is 1.

 vlan-id: Configure the value of VLAN ID, its range from 1 to 4094.

 dot1p: Configure the specified application to tag the flow by using

802.1p priority, at the same time, use vlan 0 to load the flow.

 cos: Configure the priority of Ethernet frame for VLAN.

 cos-value: Configure the value of Ethernet frame priority for VLAN, its

range from 0 to 7, the default value is 5.

 dscp: Configure DSCP of VLAN.

 dscp-value: DSCP value input by the user, its range from 0 to 63, the

default value is 46.

 Default: No network policy is configured on the port.

 Command Mode: Port mode

 Usage Guide: User is able to configure the network policy of many kinds on a port, but

their application types cannot repeat, and a kind of network policy corresponds to a

LLDP-MED network policy TLV. If user configures multi-policy for a port, it will send

multi-LLDP-MED network policy TLV to a LLDP packet. If user does not configure any

network policy, no LLDP-MED network policy TLV is sent to LLDP packet.

 Example: Configure the network policy with the application type of voice on port 19.

 Switch(Config-If-Ethernet1/0/19)# network policy voice tag tagged vid 2 cos 6 dscp 23

10.12 show lldp

 Command: show lldp

 Function: Show the global LLDP and LLDP-MED configuration.