Aten CS724KM [41/99] Power on detection

Chapter 4. Hotkey Operation

Power on Detection

With Power on Detection, if the focus computer is powered off, the switch will

automatically switch to the next powered-on computer. Power on Detection

can be enabled or disabled. The default setting is enabled. To disable Power on

Detection, do the following:

1. Invoke HSM (see page 24

2. Press and release [E].

This procedure is a toggle. Repeat to revert to the original setting.

Screen Size

Sets the screen size of each monitor so that the CS724KM knows to switch

computers when the mouse cursor moves from one computer's screen to the

next. You can also use the Boundless Switching Configuration Utility to set the

screen size (see Configuration Utility, page 46). To set the screen size, do the

following:

1. Bring the KM focus to the port you want to set up.

2. Invoke HSM (see page 24

3. Press [L].

4. In the upper left corner of the display, click the left mouse button and hold

it down while you move the cursor to the bottom right corner of the

display, and then release.

Two beeps signify the operation was successful.

5. Repeat this procedure for each monitor connected to your installation.

Note: 1. If the display’s resolution changes, you must reset the screen size

to the correct resolution or Bounless Switching may not work

correctly.

2. This hotkey will be removed for extended desktops boundless

switching with CS724KM’s firmware version v1.1.102 or higher.