Zyxel GS1900-8HP [103/246] The global screen

Chapter 19 Configuration: Port

GS1900 Series User’s Guide

103

19.4.1 The Global Screen

In the navigation panel, click Configuration > Port > PoE > Global to display the screen as

shown. Use this screen to configure Power over Ethernet (PoE) global settings.

Figure 97 Configuration > Port > PoE > Global

The following table describes the labels in this screen.

19.4.2 The Port Screen

Use this screen to view Switch port PoE settings and select ports for configuration. Click

Configuration > Port > PoE > Port to open this screen.

Table 64 Configuration > Port > PoE > Global

LABEL DESCRIPTION

PoE Mode Select the power management mode you want the Switch to use.

• Classification - Select this if you want the Switch to reserve the Max Power (mW) to

each PD according to the priority level. If the total power supply runs out, PDs with

lower priority do not get power to function.

• Consumption - Select this if you want the Switch to manage the total power supply so

that each connected PD gets a resource. However, the power allocated by the Switch

may be less than the Max Power (mW) of the PD. PDs with higher priority also get more

power than those with lower priority levels.

Pre-Allocate This field is only available on GS1900-8HP (Revision B1) and GS1900-10HP only.

Select Enable to have the Switch pre-allocate power to each port based on the

classification of the PD device. Otherwise, select Disable.

Power Up

Sequence Delay

This field is only available on GS1900-8HP (Revision B1) and GS1900-10HP only.

Select Enable to allow PoE ports to be powered up one-by-one randomly or Disable to

allow them all to be powered up at the same time.

Apply Click Apply to save the changes.

Cancel Click Cancel to discard the changes.