Moxa AWK-6222-EU-T [90/101] Configuration by telnet and ssh consoles

AWK-6222 User’s Manual Software Installation/Configuration

5-5

ATTENTION

If you unplug the RS-232 cable or trigger DTR, a disconnection event will be invoked to enforce

logout for network security. You will need to log in again to resume operation.

Configuration by Telnet and SSH Consoles

You may use a Telnet or SSH client to access the AWK-6222 and manage the console over a

network. To access the AWK-6222’s functions over the network from a PC host that is connected

to the same LAN as the AWK-6222, you need to make sure that the PC host and the AWK-6222

are on the same logical subnet. To do this, check your PC host’s IP address and subnet mask.

NOTE

The AWK-6222’s default IP address is 192.168.127.253 and the default subnet mask is

255.255.255.0 (for a Class C network). If you do not set these values properly, please check the

network settings of your PC host and then change the IP address to 192.168.127.xxx and subnet

mask to 255.255.255.0.

Follow the steps below to access the console utility via Telnet or SSH client.

1. From Windows Desktop, run Start > Run, and then use Telnet to access the AWK-6222’s IP

address from the Windows Run window. (You may also issue the telnet command from the

MS-DOS prompt.)