Honda AFRICA TWIN XRV750 (1987-2002) [67/291] 18 engine clutch and transmission

Содержание

Похожие устройства

2 18 Engine clutch and transmission 5 23a Remove the pivot cap then slacken the nut arrowed 5 23b Lower front mounting bolt nut A upper front mounting bolt nut B 5 24a Unscrew the bolts arrowed and remove the support piece 5 24b Withdraw the upper front mounting bolt 5 24c Unscrew the nuts and remove the right hand bracket 5 24d then withdraw the bolts and remove the left hand piece noting how all components fit XL600V models 23 If the swingarm has not been removed remove the cap from each end of the swing arm pivot rear mounting bolt then slacken the 5 25a Unscrew the nut 5 25b and withdraw the swingarm pivot rear mounting bolt nut see illustration Also slacken the lower front mounting bolt nut see illustration 24 Unscrew the two bolts securing the fairing side panel and belly pan support piece and remove it noting how it fits see illustration Unscrew the nut on the upper front engine mounting bolt see illustration 5 23b and withdraw the bolt see illustration Unscrew the nuts on the upper front mounting bracket bolts then withdraw the bolts and remove the brackets noting how they fit see illustrations 25 Check that the engine is properly supported on the jack If the swingarm has not been removed unscrew the nut on the swingarm pivot rear mounting bolt Withdraw the swingarm pivot rear mounting bolt then push the swingarm back so that it is clear of the engine see illustrations 26 Check that all wiring cables and hoses are well clear of the engine that the engine is still properly supported on the jack and that 5 26a Unscrew the nut withdraw the bolt and remove the spacer your assistant s is are ready Unscrew the nut on the lower front mounting bolt then withdraw the bolt and remove the spacer that fits between the right hand frame bracket and the engine see illustrations Move the back of the engine to the right and disengage the drive chain from around the transmission output shaft and gearchange shaft see illustration Lift the front of the engine so that the front cylinder is raised then tilt it to the left and manoeuvre the engine out from the left hand side making sure the sump clears the frame tube to avoid scratching it see illustration XL650V models 27 If the swingarm has not been removed remove the cap from each end of the swingarm pivot rear mounting bolt then slacken the nut Also slacken the lower front mounting bolt nut 5 26b Disengage the drive chain from around the shaft