Hikoki CG 40EAF [15/2] English

English

15

TROUBLESHOOTING

Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your

dealer or the HiKOKI Authorized Service Center.

Condition Cause Remedy

Engine does not

start

Fuel

plug is wet

1.

Disconnect the spark plug and allow to dry

2. Pull the starter handle 5 or 6 times to

3. Attach the spark plug

4. Set the choke lever to RUN position and

pull the starter handle

Fuel fi lter is clogged with dirt Clean the fuel fi lter

Fuel pipe is bent or disconnected Ensure that the fuel fl ows smoothly

Carburetor malfunction Contact HiKOKI Authorized Service Centers

Electrical

Electrode gap is too big Adjust the gap to 0.6mm

Electrical system malfunction Contact HiKOKI Authorized Service Centers

Other

Muffl er exhaust port is clogged with

carbon

Contact HiKOKI Authorized Service Centers

for repair

Engine starts

but cuts out

straightaway

Engine is apt to

cut out

Fuel

Choke lever is in START position Set the choke lever to RUN position

Air has got into fuel system Reconnect the fuel pipe or joint

Carburetor malfunction Contact HiKOKI Authorized Service Centers

Electrical

system

Ignition failure

Spark plug failure Replace with new spark plug

Electrical system failure Contact HiKOKI Authorized Service Centers

Other

Engine overheating

Dirty air cleaner Clean

Contact HiKOKI Authorized Service Centers

Abnormal vibration

Cutting attachment is not properly

installed

See “Installation of cutting attachment”

Handle, handle bracket or other

fastening part is loose

Check and tighten

Blade is bent or damaged Replace with new blade

Grass is wrapped round gear case Remove grass