Honda TRANSALP XL600-650V (1987-2002) [102/291] Engine clutch and transmission 2 53

Содержание

Похожие устройства

Engine clutch and transmission 2 53 25 3a Unscrew the bolts arrowed 25 3d and the pump dowel 3 Unscrew the remaining two bolts securing the pump assembly to the crankcase then remove the pump along with its oil pipe see Illustrations Remove the two oil passage collars from the crankcase and discard their O rings as new ones must be used see illustration Remove the pump dowel if it is loose It could be In either the pump or the crankcase see illustration 25 3b and remove the pump assembly 25 3c Remove the oil passage dowels 25 4 Remove the oil pipe and discard its O rings 25 5 Remove the strainer noting how it fits rotor tip and the outer rotor with a feeler gauge and compare it to the maximum clearance listed in the specifications at the beginning of the Chapter see illustration If the clearance measured is greater than the maximum listed replace the pump with a new one 10 Measure the clearance between the outer 25 6a Unscrew the bolts arrowed 25 6b and draw the rotor housing off the pump 25 6c Remove the dowels arrowed if loose 25 8 Scoring is evident on this pump rotor and in the housing Inspection 4 Remove the oil pipe from the pump and discard its O rings as new ones must be used see illustration 5 Remove the oil strainer from the pump noting how it fits see illustration Discard the seal as a new one must be used 6 Unscrew the three bolts and separate the rotor housing from the pump body see Illustration Remove the dowels from either the housing or the body if they are loose see illustration 7 Withdraw the pump drive shaft and remove the thrust washer and the drive pin noting how it locates in the shaft and in the notches in the inner rotor Remove the inner and outer rotors from the pump body Note whether the punch mark on the outer rotor in or out of the housing so it can be installed the same way round Clean all the components In solvent 8 Inspect the pump body and rotors for scoring and wear see illustration If any damage scoring or uneven or excessive wear Is evident replace the pump with a new one individual components are not available 9 Measure the clearance between the inner