Kawasaki KLE500 (2004) [336/401] Battery terminal voltage
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Kawasaki KLE500 (2004) [336/401] Battery terminal voltage

Kawasaki KLE500 (2004) [336/401] Battery terminal voltage
16-22 ELECTRICAL SYSTEM
Battery
When a fast charge is inevitably required, do it following precisely the maximum charge current
and time conditions indicated on the battery.
CAUTION
This battery is designed to sustain no unusual deterioration if refresh-charged according
to the method specified above.
H
owever, the battery’s performance may be reduced noticeably if charged under c o n d i -
tions other than given above.
Never remove the seal cap during refresh charge.
If by chance an excessive amount of gas is generated due to overcharging, the safety valve
operates to keep the battery safe.
3) When you do not use the motorcycle for months:
Give a refresh charge before you store the motorcycle and store it with the negative lead removed.
Give a refresh charge once a month during storage.
4) Battery life:
If the battery will not start the engine even after several refresh charges, the battery has exceeded
its useful life. Replace it. (Provided, however, the vehicle’s starting system has no problem.)
WARNING
Keep the battery away from sparks and open flames during charging, since the battery
gives off an explosive gas mixture of hydrogen and oxygen. When using a battery charger,
connect the battery to the charger before turning on the charger. This procedure prevents
sparks at the battery terminals which could ignite any battery gases.
No fire should be drawn near the battery, or no terminals should have the tightening loos-
ened.
The electrolyte contains sulfuric acid. Be careful not to have it touch your skin or eyes. If
touched, wash it off with liberal amount of water. Get medical attention if severe.
Interchange
The sealed battery can fully display its performance only when combined with a proper vehicle elec-
tric system. Therefore, replace the sealed battery only on a motorcycle which was originally equipped
with the sealed battery.
Be careful, if a sealed battery is installed on a m otorcycle which had an ordinary battery as original
equipment, the sealed battery’s life will be shortened.
Charging Condition Inspection
Battery charging condition can be checked by measuring
battery terminal voltage.
•
Remove the seat (see Seat Removal in the Frame chap-
ter).
•
Disconnect the battery terminals.
CAUTION
Be sure to disconnect the negative terminal first.
•
Measure the battery terminal voltage.
NOTE
○
Measure with a digital voltmeter [A] which can be read
one decimal place voltage.
If the reading is below the specified, refreshing charge is
required.
Battery Terminal Voltage
Standard:
12.8 V or m ore

Содержание

Похожие устройства

Скачать