D-Link DGS-3700-12G [114/338] Config bandwidth_control

DGS-3312SR Layer 3 Gigabit Switch

108

config bandwidth_control

of packets received by the above specified ports.

 <value 1-1000> − Specifies the packet limit, in Mbps, that

the above ports will be allowed to receive.

Restrictions Only administrator-level users can issue this command.

Example usage:

To configure bandwidth control:

DGS-3312SR:4#config bandwidth_control 1:1-1:10 tx_rate 10

Command: config bandwidth_control 1:1-1:10 tx_rate 10

Success.

DGS-3312SR:4#

show bandwidth_control

Purpose Used to display the bandwidth control configuration on the switch.

Syntax

show bandwidth_control {<portlist>}

Description

The show bandwidth_control command displays the current

bandwidth control configuration on the switch, on a port-by-port

basis.

Parameters

<portlist> − Specifies a range of ports to be configured. The port

list is specified by listing the lowest switch number and the

beginning port number on that switch, separated by a colon. Then

the highest switch number, and the highest port number of the

range (also separated by a colon) are specified. The beginning

and end of the port list range are separated by a dash. For

example, 1:3 specifies switch number 1, port 3. 2:4 specifies

switch number 2, port 4. 1:3-2:4 specifies all of the ports between

switch 1, port 3 and switch 2, port 4 − in numerical order.

Using this command without adding a portlist entry will show the

bandwidth control for all ports in the switch stack.

Restrictions None.

Example usage:

To display bandwidth control settings:

DGS-3312SR:4#show bandwidth_control 1:1-1:10

Command: show bandwidth_control 1:1-1:10

Bandwidth Control Table