D-Link DGS-3700-12G [129/338] Config gvrp

DGS-3312SR Layer 3 Gigabit Switch

123

config gvrp

Then the highest switch number, and the highest port number of

the range (also separated by a colon) are specified. The beginning

and end of the port list range are separated by a dash. For

example, 1:3 specifies switch number 1, port 3. 2:4 specifies

switch number 2, port 4. 1:3-2:4 specifies all of the ports between

switch 1, port 3 and switch 2, port 4 − in numerical order.

all − Specifies all of the ports on the switch.

state [enable | disable] − Enables or disables GVRP for the ports

specified in the port list.

ingress_checking [enable | disable] − Enables or disables ingress

checking for the specified port list.

acceptable_frame [tagged_only | admit_all] – This parameter

states the frame type that will be accepted by the switch for this

function. tagged_only implies that only VLAN tagged frames will

be accepted, while admit_all implies tagged and untagged frames

will be accepted by the switch.

pvid <vlanid 1-4094>– Specifies the default VLAN associated with

the port.

Restrictions Only administrator-level users can issue this command.

Example usage:

To set the ingress checking status, the sending and receiving GVRP information :

DGS-3312SR:4#config gvrp 1:1-1:4 state enable ingress_checking

enable acceptable_frame tagged_only pvid 2

Command: config gvrp 1:1-1:4 state enable ingress_checking enable

acceptable_frame tagged_only pvid 2

Success.

DGS-3312SR:4#

enable gvrp

Purpose Used to enable GVRP on the switch.

Syntax

enable gvrp

Description

This command, along with disable gvrp below, is used to enable

and disable GVRP on the switch, without changing the GVRP

configuration on the switch.

Parameters None.

Restrictions Only administrator-level users can issue this command.