D-Link DGS-3700-12G [145/338] Ommands

DGS-3312SR Layer 3 Gigabit Switch

139

IGMP COMMANDS

The IGMP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following

table.

Command Parameters

config igmp [ipif <ipif_name 12> | all] {version <value 1-2> | query_interval

<sec 1-65535> max_response_time <sec 1-25> |

robustness_variable <value 1-255> |

last_member_query_interval <sec 1-25> | state [enable | disable]

show igmp {ipif <ipif_name 12>}

show igmp group {group <group>} {ipif <ipif_name 12>}

Each command is listed, in detail, in the following sections.

config igmp

Purpose Used to configure IGMP on the switch.

Syntax

config igmp [ipif <ipif_name 12> | all] {version <value 1-2> |

{query_interval <sec 1-65535> | max_response_time <sec 1-

25> | robustness_variable <value 1-255> |

last_member_query_interval <sec 1-25> | state [enable |

disable]

Description This command allows you to configure IGMP on the switch.

Parameters

<ipif_name 12> − The name of the IP interface for which you

want to configure IGMP.

all − Specifies all the IP interfaces on the switch.

version <value 1-2> − The IGMP version number.

query_interval <sec 1-25> − The time in seconds between

general query transmissions, in seconds.

max_response_time <sec 1-25> − Enter the maximum time in

seconds that the switch will wait for reports from members.

robustness_variable <value 1-255> − This value states the

permitted packet loss that guarantees IGMP.

last_member_query_interval <value 1-25> − The Max Response

Time inserted into Group-Specific Queries sent in response to

Leave Group messages, and is also the amount of time between

Group-Specific Query messages. The default is 1 second

state [enable | disable] − Enables or disables IGMP for the

specified IP interface.

Restrictions Only administrator-level users can issue this command.

Example Usage: