D-Link DGS-3700-12G [214/338] Config 802 x auth_parameter

DGS-3312SR Layer 3 Gigabit Switch

208

config 802.1x auth_parameter

enable_reauth [enable | disable] − Determines whether or not the

switch will re-authenticate. Enabled causes re-authentication of

users at the time interval specified in the Re-authentication Period

field, above.

Restrictions Only administrator-level users can issue this command.

Example usage:

To configure 802.1x authentication parameters for ports 1 – 20 of switch 1:

DGS-3312SR:4#config 802.1x auth_parameter ports 1:1 – 1:20 direction both

Command: config 802.1x auth_parameter ports 1:1-1:20 direction both

Success.

DGS-3312SR:4#

config 802.1x init

Purpose Used to initialize the 802.1x function on a range of ports.

Syntax

config 802.1x init [port_based ports [<portlist | all>] |

mac_based [ports] [<portlist> | all] {mac_address <macaddr}]

Description

The config 802.1x init command is used to immediately initialize

the 802.1x functions on a specified range of ports or for specified

MAC addresses operating from a specified range of ports.

Parameters port_based – This instructs the switch to initialize 802.1x functions

based only on the port number. Ports approved for initialization

can then be specified.

 <portlist> − Specifies a range of ports. The port list is

specified by listing the lowest switch number and the

beginning port number on that switch, separated by a colon.

Then the highest switch number, and the highest port number

of the range (also separated by a colon) are specified. The

beginning and end of the port list range are separated by a

dash. For example, 1:3 specifies switch number 1, port 3. 2:4

specifies switch number 2, port 4. 1:3-2:4 specifies all of the

ports between switch 1, port 3 and switch 2, port 4 − in

numerical order.

 all − Specifies all of the ports on the switch.

mac_based - This instructs the switch to initialize 802.1x functions

based on the MAC address of a device on a specific port or range

of ports. MAC address approved for initialization can then be

specified.

 <portlist> − Specifies a range of ports. The port list is

specified by listing the lowest switch number and the