D-Link DGS-3700-12G [249/338] Ime and

DGS-3312SR Layer 3 Gigabit Switch

243

TIME AND SNTP COMMANDS

The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NPT)) commands in the Command

Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.

Command Parameters

config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}

show sntp

enable sntp

disable sntp

config time <date ddmmmyyyy > <time hh:mm:ss>

config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}

config dst

[disable | repeating {s_week <start_week 1-4,last> | s_day <start_day

sun-sat>| s_mth <start_mth 1-12> | s_time <start_time hh:mm> |

e_week <end_week 1-4,last> | e_day <end_day sun-sat> | e_mth

120]} | annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> |

s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth

120]}]

show time

Each command is listed, in detail, in the following sections.

config sntp

Purpose Used to setup SNTP service.

Syntax

config sntp {primary <ipaddr> | secondary <ipaddr> | poll-

interval <int 30-99999>}

Description Use this command to configure SNTP service from an SNTP

server. SNTP must be enabled for this command to function (See

enable sntp).

Parameters

primary − This is the primary server the SNTP information will be

taken from.

 <ipaddr> − The IP address of the primary server.

secondary − This is the secondary server the SNTP information

will be taken from in the event the primary server is unavailable.

 <ipaddr> − The IP address for the secondary server.

poll-interval <int 30-99999> − This is the interval between

requests for updated SNTP information. The polling interval

ranges from 30 to 99,999 seconds.