D-Link DGS-3700-12G [234/338] Ommands

DGS-3312SR Layer 3 Gigabit Switch

228

STACKING COMMANDS

The stacking configuration commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)

in the following table.

Command Parameters

config stacking mode [ disable {ports [<portlist> | <int>]} | enable {ports [<portlist> |

<int>]}]

show stacking mode

Each command is listed, in detail, in the following sections.

NOTE: As a stand-alone switch or as a master switch in a switch stack,

the switch number will be referred to as 15 for all configurations, graphs

and tables.

config stacking mode

Purpose Used to configure the stacking mode.

Syntax

config stacking mode [ disable {ports [<portlist>]} | enable

{ports [<portlist>]}]

Description This command is used to configure the stacking function for the

switch by enabling or disabling stacking, along with a list of ports.

Parameters disable - To disable the switch to function in a stacked group.

The user may disable this stacking function by port, by adding

the ports parameter along with the appropriate port to be

disabled.

 <portlist> - Specifies a range of ports for which the

stacking mode on the switch will be enabled. The port list is

specified by listing the lowest switch number and the

beginning port number on that switch, separated by a colon.

Then the highest switch number, and the highest port

number of the range (also separated by a colon) are

specified. The beginning and end of the port list range are

separated by a dash. For example, 1:3 specifies switch

number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-

2:4 specifies all of the ports between switch 1, port 3 and

switch 2, port 4 − in numerical order.

enable – To enable the switch to function in a stacked group. The

user may employ this stacking function by port, by adding the

ports parameter along with the appropriate port to be enabled.

 <portlist> - Specifies a range of ports for which the

stacking mode on the switch will be enabled. The port list is

specified by listing the lowest switch number and the

beginning port number on that switch, separated by a colon.