D-Link DGS-3700-12G [290/338] Ommands

DGS-3312SR Layer 3 Gigabit Switch

284

RIP COMMANDS

The RIP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following

table.

Command Parameters

config rip [ipif <ipif_name 12> | all] {authentication [enable <password

v2_only] | rx_mode [v1_only | v2_only | v1_or_v2 | disable]

state [enable | disable]}

enable rip

disable rip

show rip ipif <ipif_name 12>

Each command is listed, in detail, in the following sections.

config rip

Purpose Used to configure RIP on the switch.

Syntax

config rip [ipif <ipif_name 12> | all] {authentication [enable

<password 16> | disable] | tx_mode [disable | v1_only |

v1_compatible | v2_only] | rx_mode [v1_only | v2_only |

v1_or_v2 | disable] state [enable | disable]}

Description This command is used to configure RIP on the switch.

Parameters

<ipif_name 12> − The name of the IP interface.

all – To configure all RIP receiving mode for all IP interfaces.

authentication [enable | disable] − Enables or disables

authentication for RIP on the switch.

 <password 16> − Allows the specification of a case-

sensitive password.

tx_mode − Determines how received RIP packets will be

interpreted – as RIP version V1 only, V2 Only, or V1

Compatible (V1 and V2). This entry specifies which version of

the RIP protocol will be used to transfer RIP packets. The

Disabled entry prevents the reception of RIP packets.

 disable − Prevents the transmission of RIP packets.

 v1_only − Specifies that only RIP v1 packets will be

transmitted.

 v1_compatible – Specifies that only RIP v1 compatible

packets will be transmitted.

 v2_only - Specifies that only RIP v2 packets will be