D-Link DGS-3700-12G [128/338] Config gvrp

DGS-3312SR Layer 3 Gigabit Switch

122

config vlan

the portlist parameter.

tagged − Specifies that the ports are to be VLAN tagged.

untagged − Specifies the ports as untagged.

forbidden − Specifies the ports as forbidden ports.

delete − Used to delete ports from the specified VLAN, in

conjunction with the portlist parameter.

<portlist> − A range of ports to add to the VLAN. The port list is

specified by listing the lowest switch number and the beginning

port number on that switch, separated by a colon. Then the

highest switch number, and the highest port number of the range

(also separated by a colon) are specified. The beginning and end

of the port list range are separated by a dash. For example, 1:3

specifies switch number 1, port 3. 2:4 specifies switch number 2,

port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3

and switch 2, port 4 − in numerical order.

advertisement [enable | disable ] − Enables or disables GVRP on

the specified VLAN.

Restrictions Only administrator-level users can issue this command.

Example usage:

To add 4 through 8 of module 2 as tagged ports to the VLAN v1:

DGS-3312SR:4#config vlan v1 add tagged 2:4-2:8

Command: config vlan v1 add tagged 2:4-2:8

Success.

DGS-3312SR:4#

config gvrp

Purpose Used to configure GVRP on the switch.

Syntax

config gvrp [<portlist> | all] {state [enable | disable] |

ingress_checking [enable | disable] | acceptable_frame

[tagged_only | admit_all] | pvid <vlanid 1-4094>}

Description This command is used to configure the Group VLAN Registration

Protocol on the switch. You can configure ingress checking, the

sending and receiving of GVRP information, and the Port VLAN ID

(PVID).

Parameters

<portlist> − A range of ports for which you want ingress checking.

The port list is specified by listing the lowest switch number and

the beginning port number on that switch, separated by a colon.