АМАТЕК AN-SGM28P24-400 [134/322] Single loop configuration example

133 / 322

a EAPSDomain

privilege mode

9.7 Single - loop configuration example

There are three sets of equipment Switch1, switch2, switch3, through the EAPS protocol

VLAN 1 protection in traffic forwarding does not form a loop, while ensuring that when Switch1,

switch2, there is a link off the standby link between switch3。According to the above requirements,

you can configure Switch1 to master mode; configure switch2 and switch3 to transit mode. Add a

protocol packet control VLAN VLAN 2。

Configuration of Switch1：

Switch1 is configured as EAPS Domain ring 1 master, control VLAN is VLAN 2, protected

VLAN is VLAN 1, primary-port is ge1/1, secondary-port is ge1/2, other configurations use default

values。

Switch#configure terminal

#Adding VLAN 2

Switch(config)#vlan database

Switch(config-vlan)#vlan 2

Switch(config-vlan)#exit

#Configure ge1/1 to be a trunk member of VLAN 1 and VLAN 2。

Switch(config)#interface ge1/1

Switch(config-ge1/1)#switchport mode trunk

Switch(config-ge1/1)#switchport trunk allowed vlan add 1,2

#Configure ge1/2 to be a trunk member of VLAN 1 and VLAN 2。