АМАТЕК AN-SGM28P24-400 [66/322] Configure super large frame

65 / 322

3.8 Configure super large frame

3.8.1 Oversize introduction

In order to achieve the port can receive super large frame, you can set the port to support the

specific super frame length。

3.8.2 Oversize configuration

The port configuration supports super frame length, in config mode, into the port

configuration mode, such as interface ge1/1, execute the following command：

Switch(config-ge1/1)# jumbo frame 2000

Super large frame length supported by display portSwitch#show jumbo frame ge1/1

Port Jumbo frame(bytes)

ge1/1 2000

3.9 Configuring redundant ports

In some special cases, such as the need to focus on the protection of certain servers linked to

the stability of the network, the switch's redundant port can provide two ports linked to the server,

and to ensure that at a time the server only one LINK UP port link network , When a port occurs

LINK DOWN, the system immediately enable another port。

When a port in the redundant port group in the LINK UP, we call the Active state; the other

hand, if a redundant port group in the LINK DOWN, we call the Disable state。

This section focuses on the configuration of redundant ports, including the following：

 Configuration of redundant ports

 Display of redundant ports

3.9.1 Configuration of redundant ports

can configure 8 sets of redundant ports, a group of redundant ports can only configure 2 ports;

one port can only be configured to a redundant port group。