АМАТЕК AN-SGM28P24-400 [64/322] Configuration of trunk group

63 / 322

3.7.2 Configuration of TRUNK group

The following command creates a manual TRUNK group in global configuration mode：

trunk <trunk-id>

Create TRUNK group, the <trunk-id> value range is 1-8, indicating the TRUNK group ID

number to be created, the most configurable 8 groups of TRUNK；After creating the success,

the TRUNK group interface name is trunk+id, such as group ID number 1 TRUNK group

interface name is trunk1。You can configure the mode with "interface trunk+id" command to

enter interface configuration mode, and then operate on the TRUNK group, such as the use of

interface command interface mode trunk1 into TRUNK 1, the configuration of the TRUNK

1。

The following command creates a static LACP TRUNK group in global configuration mode：

trunk <1-8> dynamic

The following command deletes a TRUNK group in global configuration mode：

no trunk <trunk-id>

When you delete a TRUNK group, you must ensure that the TRUNK group does not have a

member port。

3.7.3 TRUNK group member port configuration

The following command in interface configuration mode of new members of TRUNK port：

trunk interface IFNAME (passive|)

<if-name> is the port name that needs to be added to the TRUNK group, and must be the two

layer interface. Each group of TRUNK can add 8 two layer interfaces at most。If the TRUNK

group is a static LACP TRUNK group, the add interface defaults to the active state and can

be configured as a passive state。

The following command deletes all the member ports of the TRUNK group in the interface

configuration mode：

no trunk interface