Stiga AUTOCLIP 140 4WD [76/708] Start up robot with no charging station

Превью страниц Страница 76 / 708

User’s manual

START-UP. ROBOT WITH CHARGING STATION

Preliminary operations:

1. Check that the grassy surface of the lawn to mow is at a height which is compatible with the

proper functioning of the robot (see technical speci cations on page 9).

2. Adjust the desired cutting height (see cutting height adjustment on page 27).

3. Check that the work area is correctly delimited and that there are no impediments to the

correct functioning of the robot as indicated in the section “Preparation and de ning the

boundaries of the work areas” and following sections.

4. Disconnect the robot from the recharging area (page 26).

5. Position the robot inside the grassy surface in an area where the grass is at least 1 metre (40.0

in.) from any obstacle.

The robot starts a daily work cycle based on the starting time of the work cycle used the last

time it was turned on. For example, to mow the lawn everyday at 1:00pm, wait for 1:00pm and

start the robot:

6. Press the OFF/ON key and wait a few seconds for the robot to turn on completely.

7. Press START/STOP key to start the robot.

At the end of the work cycle, the robot will go back to the recharging station to charge the

batteries. If the daily work cycle is not suf cient to cover the mowing area, the robot will execute

a new work cycle.

Important

If a sprinkler system needs to be programmed, bear in mind that the work

cycles will continue one after the other for 12 hours starting from the daily start

time.

At the end of the daily cycles, the robot will wait for the next day at the same time to start a new

work cycle.

If the robot is paused during the work cycle without being turned off and then started again, the

start time of the work cycle remains the same as that of the last time the robot was turned on.

To send the robot to the charging station during the work cycle, keep the START/STOP button

pressed for 4 seconds until the robot starts moving again in search of the charging station.

To execute another work cycle while the robot is in the charging station without waiting for the

set time, press START/STOP. The robot exits from the charging station and executes a work

cycle. On completion, it will go back to the charging station and will start mowing at the time