Stiga AUTOCLIP 140 4WD [81/708] Robot stop

Превью страниц Страница 81 / 708

User’s manual

ROBOT STOP

The robot stops automatically if the following conditions are detected:

• Lawn mowed: The sensor has detected that the lawn has been mowed and therefore, does

not require further mowing. Recharge the batteries and start the robot again after one or two

days based on the growth of the grass.

• No grass present or problems on the wire: The grass sensors have not detected the pre-

sence of grass for an extended period, or the robot remains blocked in an attempt to go back

inside the perimeter.

• Discharged batteries: The batteries have used up their operating capacity.

• Batteries in protection: When the batteries have reached a capacity which is lower than the

level of the discharged batteries, the robot completely turns off without displaying any indica-

tion. In this case, connect the robot to the recharger. The robot will not turn on immediately,

as normally occurs, but only after a few minutes.

IN PAUSE

in pause / in pause due to low battery

Robot in standby. Press the START/STOP

key to display the status of the LEDs.

the lawn has been mowed

no lawn present or problems with

perimeter wire placement

The robot was unable to reach the

recharging station. Guide wire interrupted

or the recharging station is positioned in

an area that is hard to reach.

No perimeter signal. Perimeter wire

interrupted or problems with the power

supply-transmitter unit

STEADY ON

SLOW FLASHING

1 FLASH

3 FLASHES

4 FLASHES

2 FLASHES