Netgear DGND3300 [25/174] Use pin entry to add a wps client

Wireless Settings

N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2

and default password of password, or using whatever LAN address and password you

have set up.

2. On the N300 wireless modem router main menu, select Add

WPS Client, and then click

Next. The following screen displays:

WPS button

By default, the Push Button (recommended) radio button is selected.

3. Either press the N300 wireless modem router dome for a few seconds, which works as a

WPS

button, or click the onscreen button.

The N300 wireless modem router tries to communicate with the

client for 2 minutes.

4. Go to the client wireless computer, and run a WPS config

uration utility. Follow the utility’s

instructions to click a WPS button.

5. Go back to the

N300 wireless modem router screen to check for a message.

The N300 wireless modem router WPS screen displays a message confirming that the

client was ad

ded to the wireless network. The N300 wireless modem router generates an

SSID and implements WPA/WPA2 wireless security. The N300 wireless modem router

will keep these wireless settings unless you change them or you clear the Keep Existing

Wireless Settings check box in the Advanced Wireless Settings screen. See Restrict

Access to Your N300 Wireless Modem Router on page 29

6. Note the new SSID and WPA/WPA2 password for the wireless network. You can view these

ttings in the Wireless Settings screen. See Manually Configure Your Wireless Settings on

page 18.

To access the Internet from any computer connect

ed to your N300 wireless modem router,

launch a browser such as Microsoft Internet Explorer or Mozilla Firefox. You should see the

N300 wireless modem router’s Internet LED blink, indicating communication to the ISP.

Note: If no WPS-capable client devices are located during the 2-minute

time frame, the SSID will not be changed, and no security will be

implemented on the N300 wireless modem router.

Use PIN Entry to Add a WPS Client

Any wireless computer or wireless adapter that will connect to the N300 wireless modem

router wirelessly is a client. The client needs to support a WPS PIN, and needs to have a

WPS configuration utility, such as the NETGEAR Smart Wizard or Atheros Jumpstart.