D-Link DGS-3000-28SC [175/444] Ipv6 route table

DGS-3000-28SC Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide

165

between 1 and 65535.

Backup State

Each IPv6 address can only have one primary route, while another route should be

assigned to the backup state. When the primary route fails, the Switch will try the

backup route. The field represents the Backup for the IPv6 configuration. This field

may be Primary or Backup.

Click the Apply button to accept the changes made.

Click the Delete All button to remove all the entries listed.

Click the Delete button to delete the corresponding entry.

Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

IPv6 Route Table

This window is used to display the current IPv6 routing table or specified route entries.

To view the following window, click L3 Features > IPv6 Route Table as shown below.

Figure 5-4 IPv6 Route Table window

The fields that can be configured are described below:

Parameter Description

IPv6 Address/Prefix

Length

Tick the check box and enter a 128-bit length IPv6 address.

IPv6 Address

Tick the check box and enter the destination IPv6 address of the route to be

displayed.

Hardware

Tick the check box to display only the routes that have been written into the chip.

Click the Find button to locate a specific entry based on the information entered.

Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

IP Forwarding Table

The IP forwarding table stores all the direct connected IP information. This window is used to view all the direct

connected IP information.

To view the following window, click L3 Features > IP Forwarding Table as shown below.

Figure 5-5 IP Forwarding Table window