D-Link DGS-3000-28SC [38/444] Command logging settings

DGS-3000-28SC Layer 2 Managed Stackable Gigabit Switch Web UI Reference Guide

Click the Edit button to re-configure the specific entry.

Click the Delete button to remove the specific entry.

NOTICE: In case of lost passwords or password corruption, refer to Appendix A Password Recovery

Procedure, which will guide you through the steps necessary to resolve this issue.

NOTE: The username and password should be less than 16 characters.

Command Logging Settings

This window is used to enable or disable the command logging settings.

To view the following window, click System Configuration > Command Logging Settings as shown below.

Figure 2-29 Command Logging Settings window

The fields that can be configured are described below:

Parameter Description

Command Logging State

Use the radio buttons to enable or disable the function.

Click the Apply button to accept the changes made.

NOTE: When the switch is under the booting procedure, all configuration commands will not be

logged. When the user uses AAA authentication to logged in, the user name should not be

changed if the user has used the Enable Admin function to replace its privilege.

Configuration Trap Settings

This window is used to configure the trap settings when the configuration is saved, uploaded and downloaded.

To view the following window, click System Configuration > Configuration Trap Settings as shown below.

Figure 2-30 Configuration Trap Settings window

The fields that can be configured are described below:

Parameter Description

Save Configuration Trap

Use the drop-down menu to enable or disable sending the trap by the SNMP

agent when the configuration is saved in NVRAM.

Upload configuration

Use the drop-down menu to enable or disable sending the trap by the SNMP