D-Link DGS-6608 — настройка метрики по умолчанию для IPv6 OSPF в маршрутизаторах [182/1106]

Превью страниц Страница 182 / 1106

DGS-6600 Series Switch mm default-metric (IPv6 OSPF)

CLI Reference Guide

172

default-metric (IPv6 OSPF)

To set the default metric for IPv6 OSPF, use the default-metric command. To

return the metric to its default value, use the no form of this command.

default-metric METRIC-VALUE

no default-metric [METRIC-VALUE]

Default METRIC-VALUE: 20

Command Mode Router configuration.

Usage Guideline The default-metric command is used in conjunction with the redistribute router

configuration command (redistribute (IPv6 OSPF) command on page 593) to

cause the current routing protocol to use the same metric value for all

redistributed routes. A default metric helps solve the problem of redistributing

routes with an incompatible metric. Whenever a metric does not convert, using a

default metric provides a reasonable substitute and enables the redistribution to

proceed.

The order of the setting precedence to determine the metric is:

set metric in redistributed command > default-metric setting.

Example The following example shows an IPv6 OSPF redistributing routes from RIP. All

redistributed routes are advertised with a metric of 10.

Syntax Description

METRIC-VALUE Default metric value. A number from 1 to 16777214.

Switch > enable

Switch # configure terminal

Switch (config) # router ipv6 ospf

Switch (config-router) # default-metric 10

Switch (config-router) # redistribute rip