D-Link DGS-6608 — настройка интервала OSPF для IPv6: руководство по командам [399/1106]

Превью страниц Страница 399 / 1106

DGS-6600 Series Switch ipv6 ospf dead-interval

CLI Reference Guide

389

ipv6 ospf dead-interval

To set the time period used, during which hello packets are not detected, before

neighbors declare the router down, use the ipv6 ospf dead-interval command.

To return to the default time, use the no form of this command.

ipv6 ospf dead-interval SECONDS [instance-id INSTANCE-ID]

no ipv6 ospf dead-interval [instance-id INSTANCE-ID]

Default Seconds: 40.

INSTANCE-ID: 0.

Command Mode Interface configuration.

Usage Guideline The interval is advertised in router hello packets. This value must be the same for

all routers and access servers on a specific network.

Example The following example sets the IPv6 OSPF dead interval to 60 seconds.

Syntax Description

SECONDS Specifies the interval in seconds. The value must be the same for all nodes on a

specific network.It can be a value in the range from 1 to 65535.

INSTANCE-ID (Optional) Instance identifier. To change this ID, please configure "no" command

first. The valid setting is from 0 to 255.

Switch > enable

Switch # configure terminal

Switch (config)# interface vlan1

Switch (config-if)# ipv6 ospf dead-interval 60