D-Link DGS-6608 — настройка BGP для IPv4 Unicast: Руководство по командам [87/1106]

Превью страниц Страница 87 / 1106

DGS-6600 Series Switch bgp default ipv4-unicast

CLI Reference Guide

bgp default ipv4-unicast

Use this command to enable the IP version 4 (IPv4) unicast address family for all

neighbors. This affects the BGP global configuration. Use the no form of the

command to disable this function.

bgp default ipv4-unicast

no bgp default ipv4-unicast

Syntax None.

Default bgp default ipv4-unicast .

Command Mode Router configuration.

Usage Guideline The bgp default ipv4-unicast command is used to enable the automatic

exchange of IPv4 address family prefixes. The neighbor activate address family

configuration command must be entered in each IPv4 address family session

before a prefix exchange will occur.

The no bgp default ipv4-unicast command is used to disable the default

behavior of the BGP routing process of exchanging IPv4 unicast addressing

information with BGP neighbor routers.

With the no bgp default ipv4-unicast command, no IPv4 unicast route

information will be advertised to neighboring devices. The correspondent

information for address family ipv4-unicast will be lost.

Example This example shows how to configure BGP defaults and activate ipv4-unicast of

a peer by default for autonomous system 65534:

You can verify your settings by entering show ip protocols bgp command.

Switch(config)# router bgp 65534

Switch(config-router)# bgp default ipv4-unicast