D-Link DGS-6608 — настройка приоритета порта STP в сетевых коммутаторах [997/1106]

Превью страниц Страница 997 / 1106

DGS-6600 Series Switch m spanning-tree port-priority

CLI Reference Guide

987

spanning-tree port-priority

This setting is used to configure the value of the STP port priority on a specified

port. It is only used for RSTP and STP version. Use the no form of this command

to reset to the default priority.

spanning-tree port-priority PRIORITY

no spanning-tree port-priority

Default PRIORITY: 128.

Command Mode Interface configuration.

Usage Guideline The port priority and the port number together form the Port Identifier. It will be

used in the computation of the port's role. This parameter is used only in RSTP /

STP-Compatible mode only. The port priority value must be divisible by 16, and a

lower priority value (number) represents a higher priority.

Both of the physical port or port-channel interfaces are valid interfaces for

configuration.

An error message will be returned if the priority is not a valid value.

Example This example shows how to configure the port priority to 0 for eth1.7.

Verify the settings by entering the show spanning-tree interface command.

Syntax Description

PRIORITY Specifies the port priority; valid values are from 0 to 240.

Switch(config)#interface eth1.7

Switch(config-if)#spanning-tree port-priority 0