D-Link DGS-6608 — настройка интервала PIM hello сообщений для VLAN интерфейса [344/1106]

Превью страниц Страница 344 / 1106

DGS-6600 Series Switch ip pim query-interval

CLI Reference Guide

334

ip pim query-interval

Use this command to configure the frequency of PIM hello message.

ip pim query-interval SECONDS

Default 30 seconds.

Command Mode VLAN interface configuration.

Usage Guideline This command is only valid for the VLAN interface.

This command is valid for both SM and DM.

A PIM router learns PIM neighbors via the hello message.

Routers configured for IP multicast send PIM hello messages to detect PIM

routers. For SM, hello messages are also used to determine which router will be

the designated router for each LAN segment.

If the router has interfaces operating in the SM mode, the designated router will

send Registration messages to the rendezvous point (RP).

Example The following example changes the PIM hello interval to 45 seconds.

Verify the settings by entering the show ip pim interface command.

Syntax Description

SECONDS The number of seconds that can be configured for the interval between Hello

messages. The range is 1 to 18000.

Switch(config)# interface vlan1

Switch(config-if)# ip pim query-interval 45