D-Link DGS-6608 — gVRP Advertise Command for VLAN Configuration Guide [247/1106]

Превью страниц Страница 247 / 1106

DGS-6600 Series Switch m gvrp advertise (Interface)

CLI Reference Guide

237

gvrp advertise (Interface)

Use the gvrp advertise command to specify that this VLAN will be advertised

out by GVRP protocol. Use no gvrp advertise to disable this function.

gvrp advertise [VLAN-ID [ , | - ] ]

no gvrp advertise [VLAN-ID [ , | - ] ]

Default Advertise.

Command Mode Interface configuration.

Usage Guideline Use the gvrp advertise interface configuration command to enable the specified

VLANs' GVRP advertise function on the specified interface. If no VLAN ID is

specified, the advertise function of all VLANs to which the specified interface

belongs will be enabled.

Both physical port and port-channel interfaces are valid for this command. If a

physical port is member of a port-channel, then this command should return an

error message to indicate it.

The GVRP advertise function cannot be enabled when the interface is in access

mode.

Example This example shows how to enabled advertise function of VLAN 1000 at

interface Ethernet eth4.1.

Verify the settings by entering the show gvrp configuration command.

Syntax Description

VLAN-ID [ , | - ]

(Optional) Specifies a VLAN. The range is 1 to 4094. Specify a single VLAN ID, a

range of VLANs separated by a hyphen, or a series of VLANs separated by

comma.

Switch(config)# interface eth4.1

Switch(config-if)# gvrp advertise 1000