D-Link DGS-6608 — обзор команды dot1v protocol-group для настройки VLAN [199/1106]

Превью страниц Страница 199 / 1106

DGS-6600 Series Switch mm dot1v protocol-group

CLI Reference Guide

189

dot1v protocol-group

Use the dot1v protocol-group global configuration command to add a protocol

to a protocol group. Use no command to remove the specified protocol group, or

to remove a protocol-based VLAN from the specified group.

dot1v protocol-group GROUP-ID frame {ethernet2 | snap | llc} TYPE-VLAUE

no dot1v protocol-group GROUP-ID [frame {ethernet2 | snap | llc} TYPE-VLAUE]

Default The default protocol-based VLAN table is empty.

Command Mode Global configuration.

Usage Guideline The dot1v protocol-group command adds a protocol to a protocol group.

By setting the command multiple times, multiple protocols can be added to the

same group.

The no dot1v protocol-group command will delete an existing protocol-based

VLAN group.

If a specific protocol is specified with the no command, then this specific protocol

will be removed from the specified group.

Example This example shows how to create a protocol-based VLAN group with id 10, and

bind protocol IPv6 (frame type is ethernet2 value is 0x86dd).

Verify the settings by entering the show dot1v protocol-group command.

Syntax Description

GROUP-ID Specifies the protocol group id to add, delete or configure. The valid GROUPID

range is 1 to 16.

frame Specifies frame type to be bound in this entry.

ethernet2 Specifies operational protocol value of Ethernet II type frames.

snap Specifies operational protocol value of SNAP type frames.

llc Specifies operational protocol value of LLC type frames.

TYPE-VLAUE Specifies the protocol value of the specific frame type. The value is in

hexadecimal form. Range is 0x0 to 0xFFFF.

Switch(config)# dot1v protocol-group 10 frame ethernet2 0x86dd