D-Link DGS-6608 — настройка типа соединения для портов коммутаторов [990/1106]

Превью страниц Страница 990 / 1106

DGS-6600 Series Switch m spanning-tree link-type

CLI Reference Guide

980

spanning-tree link-type

To configure a link type for a port, use the spanning-tree link-type command. To

return to the default settings, use the no form of this command.

spanning-tree link-type {point-to-point | shared}

no spanning-tree link-type

Default Link type is automatically derived from the duplex setting unless the link-type is

explicitly configured.

Command Mode Interface configuration.

Usage Guideline A full-duplex port is considered to have a point-to-point connection; whereas

conversely, a half-duplex port is considered to have a shared connection. The

port cannot transit into forwarding state rapidly by setting the link type to shared-

media. Hence, auto-determination of the link-type by the STP module is

recommended.

This configuration will take effect on all the spanning-tree modes. Both the

physical port and the port-channel interfaces are valid for this command.

Example This example shows how to configure the link type to point-to-point for eth1.7.

Verify the settings by entering the show spanning-tree interface command.

Syntax Description

point-to-point Specifies that the port's link type is point-to-point.

shared Specifies that the port's link type is a shared media connection.

Switch(config)# interface eth1.7

Switch(config-if)# spanning-tree link-type point-to-point