D-Link DGS-6608 — настройка интервала обнаружения петли для коммутаторов [467/1106]

Превью страниц Страница 467 / 1106

DGS-6600 Series Switch m loopback-detection interval-time

CLI Reference Guide

457

loopback-detection interval-time

Use the command to configure timer interval. Use no command to return the

default settings.

loopback-detection interval-time SECONDS

no loopback-detection interval-time

Default The default setting is 10 seconds.

Command Mode Configuration mode.

Usage Guideline The timer interval of the device will transmit the CTP (Configuration Test

Protocol) packets periodically to detect a loop-back event. If the loopback

detection mode is port-based, LBD will per port send the CTP packets.

Oppositely, LBD will per port per VLAN send the CTP packets periodically on

VLAN base mode.

Example This example shows how to configure the time interval.

You can verify your settings by entering the show loopback-detection

command.

Syntax Description

interval-time

SECONDS

The time interval (in seconds) at which the device transmits all the CTP

(Configuration Test Protocol) packets to detect the loop-back event. The valid

range is from 1 to 32767.

Switch# configure terminal

Switch(config)# loopback-detection interval-time 20

Switch(config)#