D-Link DGS-6608 — настройка максимального значения векторного пути в MPLS [504/1106]

Превью страниц Страница 504 / 1106

DGS-6600 Series Switch m mpls ldp max-path-vector

CLI Reference Guide

494

mpls ldp max-path-vector

Use this command to configure the maximum path vector value allowed for loop

detection. Use the no form of this command to restore the default value.

mpls ldp max-path-vector VALUE

no mpls ldp max-path-vector

Default The default value is 254.

Command Mode MPLS router configuration mode.

Usage Guideline The path vector value is valid with the loop detection of the LDP instance

enabled. If the LDR ID number that is in the path vector list of the label mapping

message or the label request message of LDP is greater than the configured

value, it is deemed that a loop occurs.

Example This example shows how to configure the maximum path vector to 30.

The user can verify their settings by entering show mpls ldp parameter

command.

Syntax Description

VALUE Maximum path vector value. The range is 1-255

Switch(config-mpls-router)# mpls ldp max-path-vector 30