D-Link DGS-6608 — настройка автоматического восстановления ошибок в коммутаторах [237/1106]

Превью страниц Страница 237 / 1106

DGS-6600 Series Switch m errdisable recovery

CLI Reference Guide

227

errdisable recovery

Use the errdisable recovery command to enable and configure the error

recovery function. Use the no command to disable the auto recovery for causes

or to return interval to default setting for causes.

errdisable recovery cause {all | loopback-detection} [interval SECONDS]

no errdisable recovery cause {all | loopback-detection} [interval]

Default Auto recovery is disabled for all causes.

If enabled, the Interval is 300 seconds.

Command Mode Global configuration.

Usage Guideline A port can be put in error disabled state (an operational state that is similar to the

link-down state) by causes such as loopback detection.

A port in error disabled state can not transmit nor receive any packets.

An error disabled port can be either manual recovered or automatically restored

by using this command.

The user can enter shutdown and then no shutdown commands to recover an

interface manually from the error-disabled state.

If auto recovery is enabled for a specific cause, the port error disabled by that

caused will be auto recovered once the cause have timed out.

Example This example shows how to set the recovery timer to 200 seconds for port

loopback-detection.

Syntax Description

all Specifies the configure auto recovery for all causes.

loopback-detection Specifies the configure auto recovery of error port caused by loopback-

detection

interval SECONDS Specifies the time, in seconds, to recover the port from an error state caused by

the specified module. The valid value is 30 to 86400.

Switch# configure terminal

Switch(config)# errdisable recovery cause loopback-detection interval 200

Switch(config)# end