D-Link DGS-6608 — настройка времени действия ключей в сетевых устройствах [624/1106]

Превью страниц Страница 624 / 1106

DGS-6600 Series Switch m send-lifetime

CLI Reference Guide

614

send-lifetime

To set the time period during which an authentication key on a key chain is valid

to be sent, use the send-lifetime command in key chain key configuration mode.

send-lifetime START-TIME {infinite | END-TIME | duration SECONDS}

Default infinite.

Command Mode Key-chain key configuration.

Usage Guideline Specify a start-time value and one of the following values: infinite, end-time, or

duration seconds.

if lifetimes are to be configured on keys, then it is recommended to use Network

Time Protocol (NTP) or another similar time synchronization method.

When there are multiple keys that are valid at a time, the first valid key will be

used. If there are no valid keys during a specific period of time, then no

authentication will be performed.

Syntax Description

START-TIME The beginning time that the key specified, by the key command, is valid to be

sent. The syntax can be either of the following:

HH:MM:SS MONTH DATE YEAR

HH:MM:SS DATE MONTH YEAR

HH-hours

MM-minutes

SS-seconds

MONTH-first three letters of the month

DATE-date (1-31)

YEAR-year (four digits)

The default start time and the earliest acceptable date is January 1, 1993.

infinite Key is valid to be sent from the start-time value on and will not expire.

END-TIME Key is valid to be sent from the start-time value until the end-time value.The

syntax is the same as that for the START-TIME. The end-time value must be

after the start-time value. The default end time is an infinite time period.

duration SECONDS Length of time (in seconds) that the key is valid to be sent. The range is from 1 to

2147483647 (signed long).