D-Link DGS-6608 — настройка метрики IPv6 RIP для интерфейса в коммутаторах [409/1106]

Превью страниц Страница 409 / 1106

DGS-6600 Series Switch ipv6 rip metric-offset

CLI Reference Guide

399

ipv6 rip metric-offset

To set the IPv6 RIP metric for an interface, use the ipv6 rip metric-offset

command. To return the metric to its default value, use the no form of this

command.

ipv6 rip metric-offset METRIC-VALUE

no ipv6 rip metric-offset

Default The default metric value is 1.

Command Mode Interface configuration.

Usage Guideline When an IPv6 RIP route is received, the interface metric value set by the ipv6 rip

metric-offset command is added before the route is inserted into the routing

table. Increasing the IPv6 RIP metric value of an interface will increase the metric

value of IPv6 RIP routes received over the interface.

Use the ipv6 rip metric-offset command to influence which routes are used.

The IPv6 RIP metric is in the hop count.

Example The following example configures a metric increment of 10 for the RIP routing

process.

Syntax Description

METRIC-VALUE Value added to the metric of an IPv6 RIP route received in a report message. A

number from 1 to 16.

Switch > enable

Switch # configure terminal

Switch (config)# interface vlan1

Switch (config-if)# ipv6 rip metric-offset 10