D-Link DGS-6608 — руководство по команде энергосбережения для сетевых устройств [583/1106]

Превью страниц Страница 583 / 1106

DGS-6600 Series Switch m power-saving

CLI Reference Guide

573

power-saving

Use the power-saving command to enable "Power Saving" function in the device.

And use the no form of this command to disable "Power Saving" function.

power-saving {phy}

no power-saving {phy}

Default Enable.

Command Mode Global configuration.

Usage Guideline The "power-saving" command can enable the "Power Saving" function on

different hardware components. Currently, one component is supported: phy.

Select the option "phy", it will set the PHY into "Power Saving" mode. The "no

power-saving" command disables this function.

The "PHY Power Saving" function could be enabled or disabled per-system

base. There are two operation modes: "low-power" mode and "normal" mode.

When power saving is enabled, the chips automatically enter "low-power" mode

if the signal from a copper link partner is lost. They will go to normal mode when

a signal is detected.

If "PHY Power Saving" function is disabled, PHY will always be in normal mode

no matter that the signal froma link partner is presented or not.

Example The following example shows how to enable/disable "Power Saving" function.

Switch(config)#power-saving

Switch(config)#

Switch(config)show power-saving

Power-saving status

============================

phy power-saving:Enabled

Switch(config)#no power-saving

Switch(config)#show power-saving

Power-saving status

============================

phy power-saving:Disabled