D-Link DGS-6608 — gVRP Interface Command Reference Guide for Network Switches [246/1106]

Превью страниц Страница 246 / 1106

DGS-6600 Series Switch m gvrp (Interface)

CLI Reference Guide

236

gvrp (Interface)

Use the gvrp interface command to enable GVRP function for a port, and use

the no gvrp command to disable the GVRP function for a port.

gvrp

no gvrp

Syntax None.

Default Disabled.

Command Mode Interface configuration.

Usage Guideline Use the gvrp interface configuration command to enable/disable the GVRP

protocol state.

Both physical port and port-channel interfaces are valid for this command. If a

physical port is member of a port-channel, then this command should return an

error message to indicate it.

The GVRP function cannot be enabled when the interface is at access mode.

Example This example shows how to enable Ethernet eth3.1 GVRP protocol state.

Verify the settings by entering the show gvrp configuration interface

command.

Switch(config)# interface eth3.1

Switch(config-if)# gvrp