D-Link DGS-6608 — руководство по настройке режима аутентификации dot1x для коммутаторов [200/1106]

Превью страниц Страница 200 / 1106

DGS-6600 Series Switch mm dot1x auth-mode

CLI Reference Guide

190

dot1x auth-mode

Use the dot1x auth-mode command to specify the 802.1x authentication mode.

dot1x auth-mode {port-based | host-based}

Default port-based mode.

Command Mode Interface configuration.

Usage Guideline The maximum number of hosts allowed to connect to an 802.1X-enabled port is

project-dependent.

Example The following example shows how to specify the authentication mode as host-

based.

Verify the settings by entering the show dot1x auth-configuration command.

Syntax Description

port-based Specifies the authentication mode as port-based. When in the port-based mode

if one applicant is successfully authenticated, other hosts that are connected to

the same port are allowed to access the port. Each port implements one

authenticator state machine.

host-based Specifies the authentication mode as host-based. When in the host-based mode,

each host is identified by its MAC address. Only hosts which are successfully

authenticated are allowed to access the port. Each MAC address implements

one authenticator state machines.

switch#configure terminal

Switch(config)#interface eth2.1

Switch(config-if)# dot1x auth-mode host-based